Hydro power can be notoriously expensive to install, but it can be done affordably with a bit of hard work and application. Outlined here are some projects presently underway that you could master too.
The first is a conventional "roman" or "horizontal" axle standard undershot waterwheel. This design is useful for a low head of water, but benefits from a large flow. These are generally used on rivers, where a large mass of water is moving slowly. There are consequences to be thought of, fish can be squished by the blades of the paddles, so screens are required by law to protect them, this leads to weed and detritus blocking the screens, with resulting power loss, but there are design solutions. Not too good for power generation, but adequate for pumping and some mechanical processes.
The second is a turbine installation. This is a serious bit of engineering with consequences. Water is extremely heavy, have a guess how heavy a cubic foot of water is? Answer comes later, and it will shock you. For a turbine a shroud needs to be constructed, which generally means a dam. A dam means a huge weight of water held back, and the failure of this dam could wreak havoc downstream, resulting in property damage and even deaths. But this turbine will provide the power needed for electricity generation, not as visually appealing as a waterwheel, a turbine is effective and generally unobtrusive, the dam lake can be scenic and have other uses, but a screen still needs to be installed to protect fish. It is 65 lbs.
There are several kinds of turbine, a propeller will extract a certain amount of energy, but it needs many more blades than a standard outboard to be efficient, think more of the inlet of an aircraft jet engine that you see as you climb the stairs of your holiday jet. Another design is the Pelton wheel, a clever arrangement that whizzes around as a jet of water hits an array of spoons welded to an axle. This is quite a magnificent machine for electricity generation, and can be seen running on You tube, just search with "Pelton"
Water has significant weight, the height of the water is its Potential energy, the speed is its Kinetic energy, all this energy is derived from the sun, evaporating water and creating wind movement to blow the moist air up land slopes, against the pull of gravity, where lower temperatures condenses and precipitates the water, giving us the potential for energy extraction.
We will look at ways of producing waterwheels from car axles, using car gearboxes instead of the classic huge cast mill wheels, that have now been generally broken up and carted off for scrap. Even welding your own Pelton assembly. With these rotating devices balance is important. Should the high speed rotating axle be unbalanced it would set up huge destructive resonances in the array, so some adjustment and care must be taken.
